Reference number
ISO 25780:2011
© ISO 2024
International Standard
ISO 25780:2011
Plastics piping systems for pressure and non-pressure water supply, irrigation, drainage or sewerage — Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin — Pipes with flexible joints intended to be installed using jacking techniques
Edition 1
2011-05
Read sample
Published (Edition 1, 2011)
This publication was last reviewed and confirmed in 2020. Therefore this version remains current.

Abstract

ISO 25780:2011 specifies the properties of the piping system and its components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) for water supply, irrigation, drainage or sewerage systems with or without pressure.

ISO 25780:2011 is applicable to GRP-UP piping systems, with flexible joints, intended to be installed using jacking techniques. It specifies the characteristics of pipes made from GRP-UP, with or without aggregates or fillers and also specifies the test parameters for the test methods referred to in ISO 25780:2011.

ISO 25780:2011 is applicable to pipes and joints with a size range from DN100 to DN4000 which are intended to be used for the conveyance of water or sewage at temperatures up to 50ºC, with or without pressure.

ISO 25780:2011 covers requirements to improve the design of the joint and specifies type test performance requirements for the joints as a function of the declared nominal pressure rating of the pipeline system and the required joint deflection capability of the system.

General information

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goal

9
Industry, Innovation and Infrastructure

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. 93
  6. 93.030
  7. ISO 25780:2011