Status : Withdrawn

This standard has been revised by ISO 20816-4:2018

Abstract

ISO 7919-4:2009 establishes provisions for evaluating the severity of in-situ, broad-band shaft vibration measured radial (i.e. transverse) to the shaft axis at, or close to, the main bearings. These are in terms of

- vibration under normal steady-state operating conditions;

- vibration during other (non-steady-state) conditions when transient changes are taking place, including run up or run down, initial loading and load changes;

- changes in vibration which can occur during normal steady-state operation.

ISO 7919-4:2009 is applicable to heavy-duty gas turbine sets used in electrical and mechanical drive applications, with fluid-film bearings, outputs greater than 3 MW and an operating speed range under load between 3 000 r/min and 30 000 r/min. This includes gas turbines coupled to other rotating machinery either directly or through a gearbox. In some cases, ISO 7919-4:2009 is not applicable to the evaluation of the vibration of the coupled equipment.

General information

  • Status
     : Withdrawn
    Publication date
     : 2009-10
    Stage
    : Withdrawal of International Standard [95.99]
  • Edition
     : 2
    Number of pages
     : 14
  • Technical Committee :
    ISO/TC 108/SC 2
    ICS :
    17.160  27.040 
  • RSS updates

Life cycle

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Store
  3. Standards catalogue
  4. ICS
  5. 17
  6. 17.160
  7. ISO 7919-4:2009