Reference number
ISO 6162-1:2012
International Standard
ISO 6162-1:2012
Hydraulic fluid power — Flange connections with split or one-piece flange clamps and metric or inch screws — Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127
Edition 2
2012-12
Read sample
ISO 6162-1:2012
52096
Published (Edition 2, 2012)
This publication was last reviewed and confirmed in 2023. Therefore this version remains current.

ISO 6162-1:2012

ISO 6162-1:2012
52096
Language
Format
CHF 129
Convert Swiss francs (CHF) to your currency

Abstract

ISO 6162-1:2012 gives general and dimensional specifications for flanged heads, split flange clamps (FCS and FCSM), one-piece flange clamps (FC and FCM), ports and mounting surfaces applicable to four-screw, split and one-piece flange clamp type tube connectors and hose fittings for use at pressures of 3,5 MPa (35 bar ) to 35 MPa (350 bar). It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals.

ISO 6162-1:2012 also recognizes the need to accommodate metric screw fasteners (type 1), as well as to provide a means to use existing inch screw fasteners (type 2).

These connections are intended for application in hydraulic systems on industrial and commercial products where it is desired to avoid the use of threaded connectors.

Surges of pressure higher than the nominal ratings will reduce the ability of the flange connections to retain the hydraulic fluid. This needs to be taken into account in the design of the hydraulic system.

General information

  •  : Published
     : 2012-12
    : International Standard to be revised [90.92]
  •  : 2
     : 21
  • ISO/TC 131/SC 4
    23.100.40 
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support